·    Construction - Headstock, tailstock, foot, tool rest base and tool rest of heavy cast iron. Bed is of heavy steel tubing.

·    Headstock . The outboard end of the drive spindle can also be used for large turning and is threaded ¾.16 left hand. The pulley system and motor are mounted to the headstock.

·    Tailstock - Slides along the full length of bed and clamps positively at any distance from drive spindle. The ram has a hand wheel advance of 2 3/8 inches with positive lock and is fitted with a No. 1 Morse taper

·    120 Volt

·    Frequency - 60 Hz

·    Maximum Length Of Cutting Feed - 40 inch  (1000 mm)

·    Max. Diameter - 14-1/4" (365 mm)

·    Height Of Cutting Tool - 7" (178 mm)

·    Motor Power - Single Phase 350 Watts

·    Spindle speed - 4 speeds

·    Turning Capacity - 356mm (14 inches) max diameter over bed. 1000mm (40 inches) max between centers

·    Pulley system - 4 speed V belt

·    Spindle speeds - 1100, 1600, 2300, 3400 rpm

·    Motor - 350W, 1400 rpm, AC 110V, 50/60 Hz